1704E3
27th April, 2025, 11:50 PM
Problem:
KVM Programming Issue and Key Learning Failed
After replacing the KVM (Keyless Vehicle Module) in a 2020 Range Rover Sport using autel im608, the key learning step fails with the error message "Key Programming Failed". The KVM was initialized properly, and the system shows that there are 0 keys programmed in both the KVM and BCM. Despite following the necessary steps, the keys cannot be programmed, and the learning process does not complete.
Steps Taken:
KVM Replacement:
The damaged KVM was replaced with a used KVM.
MCU (SPC560B60L3) was CHANGED AND reprogrammed to make the KVM virgin using VVDI Prog.
autel im608 Programming:
The KVM replacement procedure was completed using autel im608
Initialization of the new KVM was performed, but the number of keys programmed on both KVM and BCM showed 0 (indicating that no keys are recognized by the system yet).
Key Learning Process Failed:
Attempted to program keys using autel im608, but the key learning step failed with the message "Key Programming Failed".
The KVM was properly initialized, and the keys seemed to be in the correct state, but the system does not recognize them during programming.
KVM Programming Issue and Key Learning Failed
After replacing the KVM (Keyless Vehicle Module) in a 2020 Range Rover Sport using autel im608, the key learning step fails with the error message "Key Programming Failed". The KVM was initialized properly, and the system shows that there are 0 keys programmed in both the KVM and BCM. Despite following the necessary steps, the keys cannot be programmed, and the learning process does not complete.
Steps Taken:
KVM Replacement:
The damaged KVM was replaced with a used KVM.
MCU (SPC560B60L3) was CHANGED AND reprogrammed to make the KVM virgin using VVDI Prog.
autel im608 Programming:
The KVM replacement procedure was completed using autel im608
Initialization of the new KVM was performed, but the number of keys programmed on both KVM and BCM showed 0 (indicating that no keys are recognized by the system yet).
Key Learning Process Failed:
Attempted to program keys using autel im608, but the key learning step failed with the message "Key Programming Failed".
The KVM was properly initialized, and the keys seemed to be in the correct state, but the system does not recognize them during programming.