help t300 nissan adapter

[skyneter]

I tried to program Nissan maxima 97 remote but my T300 clone from china did not have tags on cables so I connect a cable which I thought it was adc136 and Nissan 2000 adapter which was written by the Chinese seller, after few seconds 1117cd voltage regulator blown up
Now I wonder what was wrong, is the Nissan 2000 adapter not ADC133
I opened the adapter and took a photo if any mate can confirm it is ADC133
And how can I check if there is a shortage or miss wire in the OBD connector

thanks

[skyneter]

any mate has adc133 adapter can remove the cover and check to confirm it

[prusony]

Picture 1117cd1.JPG this adapter ADC-133 i`m sure!
Cable "NISSAN-2000" can not be !!! connected to T300 without dongle ADC-133 !!
(Maybe you did it ?.......)

[skyneter]

Thanks prusony
T300 is still working adc133 is damaged the car is not obd2 socket so I used the only cable which fits in maxima 97 socket
I think I have to check if there is a fault in the socket cause OEM radio is replaced and may be is miss wired

[Ashraf6119]

Thanks prusony
T300 is still working adc133 is damaged the car is not obd2 socket so I used the only cable which fits in maxima 97 socket
I think I have to check if there is a fault in the socket cause OEM radio is replaced and may be is miss wired


Hello,

Very true most of the time when after market Radio is fitted and if the wiring's is done wrong way around that's what get, even if you plug in any other Diagnostic tool it will F**K it up so very careful with this Car.

Disconnect the Radio wiring's and try again.

Good Luck

Ash