vw toureg 2003

[ezenigbo]

friends please i need help.this vw toureg 2003 refusedto desplay any thing on the screen when ignation is on .so the car cannot crank,and cannot start,i joined the 2 wires in the brake switch and it displaye but no cranking.then i was able to do the total scannaning,please help me explain the scanning,is immo off possible?

[yasser]

Imo of is NOT solution you needed.
Check all fuses.
How it hapen ??? car stop while is in driving, or car was OK and when you try to start then you had a problem.
Does some made repairing on something before you?
.....?

Also, before an year customer of mine had problem with tuareg and he go in official service, problem was cosely same, nothing on screen, i do not remember what was working, but in service they change dashboard.

[ezenigbo]

that was just how the car was brougt to me from another technican that tried to start it,what can i do to make the engine run?

[Ashraf6119]

Hi

According to your scan report it looks like you don't have communication with most of the modules, there for i would advise you to check all fuses and relays and mostly the fuse box which is in the engine bay, check that fuse box for water or any damp in there.

Hope This Helps

Ash

[ezenigbo]

ok, but someone told me that i should change the steering lock,does the scanning report that? also the wires that go to brake pedal switch are scatered,do you know the correct connection?

[Ashraf6119]

Hi

Look at this faults :


Address 05: Acc/Start Auth. Labels: 3D0-909-13x-05.lbl
Part No SW: 3D0 909 135 K HW: 5WK 470 25
Component: Kessy 6400
Coding: 0000232
Shop #: WSC 31414 000 00000

Part No: XXXXXXXXXXX
Component: ELV XXXX


00185 - Control Circuit; Relay for Supply Voltage Terminal 15
009 - Open or Short to Ground

00186 - Control circuit; Relay for Supply Voltage Terminal 15SV
006 - Short to Plus

00576 - Terminal 15
009 - Open or Short to Ground


Follow up this fault, have you tried to clear the fault code and see which ones come back.

Ash

[Wolfpack]

I looked over the codes you got. First thing i would do is wire the brake pedal switch to what is should be. Then check where the power comes in. Either something has got wet or a main fuse is bad. remember the person before you was lost and most likely cause more bad than good. Always check basics cause computers are stupid and only do what they are told. Good luck

[ezenigbo]

i have wired the brake switch and car have started,but can not accelerate when throtle is pressed,it does as if it is not pressed and the car will off after about 1 minute time

[Ashraf6119]

Hi

Have you cleared all fault codes :questionmark:.........Make sure you clear all fault codes in all modules than, start her again and see what new fault codes you have and post them here.

Hope This Helps

Ash

[ezenigbo]

this very car has spoilt again,this is the result from immo diagnosis,is there no solution of immo off?