yasser
5th June, 2010, 11:34 PM
Hi, Folks,
I have problem with airbag unit of
Mercedes E class W211 270CDI
Problem is in communication between ZGW (zentrales gateway)
and airbag module.
A211 820 94 85 HW:47/03 SW18/04
Temic 4137 Armada 16 RD EXTENSION 3
I check pover on airbag connector as theyshow in DAS.
Pin1 - +12v
pin2 - +12v
Pin84 - GND
Also I check cables between airbag module and zgw. Cables are OK.
Star diagnosis gives error (no communication or unit not instaled.)
I take other unit from working 100% good car. I connect it and check again with star diag.
Star was connect it sucsessful with this airbag module.
Now I'm sure that original module is not working.
I tryed to read MCU with programmer, but not sucsess.
Chip in 912DG128 112pin.
Is there chance this chip i to be secured OR burned?
Any one had a problem with it and give some solution for repairing ?
......OR I have to find another module to replace it?
Thank you.
I have problem with airbag unit of
Mercedes E class W211 270CDI
Problem is in communication between ZGW (zentrales gateway)
and airbag module.
A211 820 94 85 HW:47/03 SW18/04
Temic 4137 Armada 16 RD EXTENSION 3
I check pover on airbag connector as theyshow in DAS.
Pin1 - +12v
pin2 - +12v
Pin84 - GND
Also I check cables between airbag module and zgw. Cables are OK.
Star diagnosis gives error (no communication or unit not instaled.)
I take other unit from working 100% good car. I connect it and check again with star diag.
Star was connect it sucsessful with this airbag module.
Now I'm sure that original module is not working.
I tryed to read MCU with programmer, but not sucsess.
Chip in 912DG128 112pin.
Is there chance this chip i to be secured OR burned?
Any one had a problem with it and give some solution for repairing ?
......OR I have to find another module to replace it?
Thank you.