Rosfar and CAS3 CMD

[carsolution]

Hi guys.
I need your opinion about Rosfar 3000 and CAS3 BDM.
I have booth but yesterday I was trying to read an EZS W211 and with booth of them I was unable to pass the security and read.
The only way was take out the processor and read it with DigimasterII.
Like you know the advantage of booth programmers is to make the reading without the need to desolder the MCU.
When I bought them they told me they pass the security of the processor and reads the file without problems.
Can you please tell me if you have experience about this programmers and if any of you already had this problems?
I just tried with this EZS and I dont know if it is an isolated problem or if the programmers are going to do the same with other modules.
Best Regards to all in the forum and have a great weekend.
Nuno

[gepakg]

by me,most secured way for reading that mcu is ETL,i met some of them that rosfar didnt unlock,but ETL do it without problem...

regards Gepa


Hi guys.
I need your opinion about Rosfar 3000 and CAS3 BDM.
I have booth but yesterday I was trying to read an EZS W211 and with booth of them I was unable to pass the security and read.
The only way was take out the processor and read it with DigimasterII.
Like you know the advantage of booth programmers is to make the reading without the need to desolder the MCU.
When I bought them they told me they pass the security of the processor and reads the file without problems.
Can you please tell me if you have experience about this programmers and if any of you already had this problems?
I just tried with this EZS and I dont know if it is an isolated problem or if the programmers are going to do the same with other modules.
Best Regards to all in the forum and have a great weekend.
Nuno