merc wsp box

[dashtec]

hi there

was wondering how i can read the hc908 mcu mask 0j66d would prefer to read in circuit and would be grateful for any help.

[parapilot]

What programer do you have?

[dashtec]

i have dataman 48pro and enigmatool i also have hc08 programmer but it cant read the eeprom once soldered on board

[tachonow]

i have dataman 48pro and enigmatool i also have hc08 programmer but it cant read the eeprom once soldered on board
Take out the chip and you will see why you cant.

[dashtec]

i dont understand what you mean, i know these can be done in circuit, do you have any pdf, so i can read in circuit thx

[tachonow]

i dont understand what you mean, i know these can be done in circuit, do you have any pdf, so i can read in circuit thx
What 908 programmer do you have ?

[dashtec]

mc68hc908az60

[tachonow]

M8! I know what chip is inside. I wanted to know what programmer you have to give right advices.

[dashtec]

http://www.etlweb.com/?ref=prod_prog_mc68hc908az60r1

[tachonow]

http://www.etlweb.com/?ref=prod_prog_mc68hc908az60r1

Realy great programmer for this job. If you dont want to take the chip out you must solder wires on desired pins for programming. Pay attention ! Programmer need to solder wires on pin 63-PTC3 and 61-PTC1 where is a bridge on pcb. For this reason you must lift them. Chip without security bits so you can programm it with this trick onboard.

[dashtec]

do you have pdf

[tachonow]

do you have pdf
Come on m8 ! Your Help Contents sw must have it.