UPA-USB problem

[chaoren]

Hi
I have a UPA writing problem.
Everything appears to work OK, reads OK, appears to program OK but when I verify, i get ALL ERRORS.

Have I done something wrong or is programmer faulty or maybe the add-on board?

[andrassh]

Same thing with mine! Don't bother yourself, if isn't giving error on reading is ok!

[chaoren]

I dont think it is OK. I read eeprom but get all zeros.

I also get 2 error on the hardware self test.

[calin_bm]

post the self-test text here

[carsolution]

Normally when Upa goes off the error is "VCC", normally the fuse in shape of transistor.
Check if the MCU you are trying to read doesnt have protection, if it has you will read only 00.
Another thing, you can be with the connection all to green indicating it is well connected but to extract info probably you must lift pins.
Another error is "programmer not found 1001" there is a patch to correct this error, if it is the case tell me and I will send it to you.
Regards,
Nuno

[chaoren]

Screen picture attached.

Any ideas?

Only played with 95160 eeproms so far. I am trying to program new chips purchased from Farnell because I broke too many pins off 95160's from Suzuki modules.

[marcio1758]

MY UPA IS WITH THIS ERROR, PLEASE send me the patch to correct it, CAN PASS ME BY PM. Many thanks in advance

""error is "programmer not found 1001" there is a patch to correct this error, if it is the case tell me and I will send it to you. """
Regards,

[ChipGods]

you have original or china clone of the programmer?

[jimthejock]

if it is an original just e/mail elrasoft and they will send you the patch for free but only if you bought from them

[darius89]

Hi, did you found solution ?
I have same problem "error is "programmer not found 1001" I have original UPA but 4 days and no answer from Elrasoft.