FAP remove from ECU

[aeroyas]

hi all, how are you? please i need help to remove FAP from the ECU on an AUDI Q7 3l V6, ecu is EDC16CP34 / 4L0 910 401 R, HW :H04, i read the dump from eeprom and i post here, please anyone can help me please? thank's a lot

[exxl]

you must read out the flash...

not eeprom...

[aeroyas]

ah okay, i try it now and send dump, thank's a lot

[aeroyas]

hello, i try to read flash using Galetto 1260 but i get error message "attenzion se communication impossible fiare un ponte tra el pin 7 kline della presa eobd al pin 72 kline del ecu motor" don't know how to resolve this, anyone have an idea about this error message? thank's in advance

[ipejasinovic]

Everything is written in message. If you don't know a Italian language, there is plenty online translators. For e.g. Google Translate (http://translate.google.com/)

[lupu_sandu]

M8, use BDM. Is best tool for this.

[exxl]

i think you can not use on this car galetto i am not 100% sure because i never use galetto since is too much unstable....

but i think this car has the ecu on can protocol and galetto can only work over k-line that's why you get this error message

if you could pull out ecu and connect it with galetto on bench then it could work with galletto i can send you pinouts for bench connecting.

but if you already will pull the ecu out then is best to use like someone before said the bdm is the securest one for this ecu.

[aeroyas]

thank's a lot freind's sorry but i dont have BDM, please exxl can you upload shematic for reading ecu outside of car?? i can open it, thank's again

[wyz1056]

aha,
read flash!
try.test car.man

[exxl]

if you still need connection on bench here is it.

good luck!