Have some doubts Sirius 32 Renault

[GolfmkI]

Have 2 ecus from 2 different cars:

------Renault Clio II PHII 1.2 8v Sirius 32N S110115000 A 8200162378
------Renault Megane 1.4 16v Sirius 32 S110030018 D 8200020950

Both cars need to be in*o off, because of UCH problems.
My questions are:

...Need any of two an emulator, or it can be done only modifying 29f200???
...Really works solution posted above by a poster? It says that making a bridge inside the 29f200, we can enable wp function and do not need emulator, I am a bit confused, I have both in*o off dumps programmed into the ecus (both of them) but I do not want to plug them before to hear your opinions, if my dumps dont workr, then I will post for help and other dumps, thanks.

If anyone says nothing I will simply connect both units, cutting the inmo line like ever, and post results.

Really thanks

[racin-snake]

the 1.4 16 v should be ok without an emulator ime sure
but i was asking the same question earlier and noone will give a straight yes or no to it ?
i would like to try this but i need a pic or maybe a how to
as the pins break on these 29f200 chips sooooo easy
anyone give us a pdf how to ???
cheers racin -snake

[fethi usta]

hello ,
I need Renault laguna 2,0 16valve pass flash program
ecu is Sirius32

[GolfmkI]

Renault Megane 1.4 16v Sirius 32 S110030018 D 8200020950

I have cut inmo line and connect the ecu, the car now starts, but only for one second. Then stops. if you try again to start it start without problem.....but again stops......seems strange. Anyone have had a similar problem


------Renault Clio II PHII 1.2 8v Sirius 32N S110115000 A 8200162378

In*o off dump that I have located for this car, seems not valid.....even renault can clip does not communicate with ecu, I have write original dump and it comms ok, so Anyone have a valid in*o off dump for these car?????

[GolfmkI]

Anyone has a solution????

[damih]

Hello,
Try this

[autorisp]

Hi guys
I have s110115000 sirius32n on clio 1.2 8V with immo problem.
I do a 'Immo clear' on flash plus renault immo emulator on pin 58. Well done. Cut wire n?58 and connect ECU.
Immo ligth work fine and car start normally.
But...... when immo is not ok the car dont start ( i bypass the relay that control starter motor ).
I note that wire 58 ( Green ) is cutting .

I check the entire job many times but all appear ok.
I have many questions:
1) Is this ECU a special 32N type ?
2) Wire 58 in this ecu is the Immo line?
3) Anyone have a tested file for "immo total" without immo emulator .

This is the original mem file: