detroit diesel bench cables

[hercamp]

hi ....I need some help with a bench cables for detroit in special to ddecIV or v...if someone know how to make one please give me some guide.

thanks a lot

[hercamp]

no problem I thonkk how to make it ...lol

[servando]

basate en el diagrama ....para el ddec q lo vayas a utilizar.....eso creo

[rp1210a]

english please

[hercamp]

in a first time I try to find for ddec...but I did...problem is with mbe..I need special bench to rom boot ...in pld and vci ...to change rating hp.

[peter21]

hi friends, some one know how to do the bench cables for DDEC II, i make one conecting data link + to C2, data link - to C1, i can read data and change parameters, but when I try to flash the ecm show me the mesage: " the ecm is not in test mode, please turn off the switch for 10 seconds, then change switch in the DDEC reprograming harness to DDEC II "

here's the schematic of ddec 2.

31718

[hercamp]

upload picture of window that appear...and about connection is right .u most be able to download cal file.

[dieselequipos]

ddecc II is a old technolog dont use same connection of ddec3 or 4... for reprogramming.

[peter21]

ddecc II is a old technolog dont use same connection of ddec3 or 4... for reprogramming.

Ok buddy, and you know how to make the connection of ddec 2 to reprogramming??????? thanks in advanced.

[Frank Diesel]

somebody can share ddec2 bench wiring diagrma to boot rom mode?

[chamberlain31]

B3 = Ignition
C1 = J1708 Data Link (-)
C2 = J1708 Data link (+)
E1 = Connect a 3.9Kohm resistor to GND
F2, G3 and H3 = GND
Also power and gnd