PDA

View Full Version : Skoda Octavia II y07 and R250 problem


mikeli
27th July, 2010, 10:16 AM
Anybody have expirience with this problem:

Dash VDO-Siemens from 07 year, inside Micronas CDC3297+24c32.
I use cloned Rasfar R250.
Lifted pins 114 and 118 on Micronas,
also tried to lift pin from crystal, and solder transparent wire of coax cable on pcb...

Always get message:
UNABLE TO ESTABLISH A LNK WITH THE PROCESSOR



Regards
Mikeli
exe123
27th July, 2010, 10:38 AM
maybe bad rosfar clone
mikeli
27th July, 2010, 10:41 AM
No its good...working fine with Golf 5 and others with similar dashboard...

Regards
Mikeli
mikeli
28th July, 2010, 07:08 AM
I made mistake it's cdc3272, I wrote it is cdc3297....
But still problem is the same...

Mikeli
exe123
28th July, 2010, 08:04 AM
CDC3272 is Maskrom version. It is not working with Rosfar. You need XProg-M
Ding-Dong
28th July, 2010, 02:11 PM
I made mistake it's cdc3272, I wrote it is cdc3297....
But still problem is the same...

Mikeli

post the dump from 24c32 eeprom (if its cdc3272)

regards
mikeli
29th July, 2010, 10:07 AM
Now it's 87168km

I need 72168km, when I recalibrated 24c32 only, dash shows 87000km!


Mikeli



post the dump from 24c32 eeprom (if its cdc3272)

regards
exe123
29th July, 2010, 11:02 AM
Try it. maybe working