PDA

View Full Version : Advice needed all DK's


pinky1970
30th July, 2010, 06:59 PM
Im just about to do a citroen berlingo 2005, with UNI Tacho 2008. On tacho showns only berlingo or berlingo 2003, no higher. open up tacho in 2003 shown dash chip 95020 to zero (is it ok just to pull off the needles instead of turning and pulling. BSI showing V1-V7 how do i know which version. tacho saying to program chip 95016, V1-V7 shown to program same chip. What the best way put the chip on to tacho to each version and when shows correct km use that version. Also show i remove both chip (dash & BSI before reading ) or is it ok to read both dash & BSI chip from the board. why can i not write when chip is corrected to the das or BSI board. Pleas i need to get this sorted for ITV test tomorrow, i have both dash and BSI on my desk.:banghead:
Ramzai
30th July, 2010, 07:06 PM
Im just about to do a citroen berlingo 2005, with UNI Tacho 2008. On tacho showns only berlingo or berlingo 2003, no higher. open up tacho in 2003 shown dash chip 95020 to zero (is it ok just to pull off the needles instead of turning and pulling. BSI showing V1-V7 how do i know which version. tacho saying to program chip 95016, V1-V7 shown to program same chip. What the best way put the chip on to tacho to each version and when shows correct km use that version. Also show i remove both chip (dash & BSI before reading ) or is it ok to read both dash & BSI chip from the board. why can i not write when chip is corrected to the das or BSI board. Pleas i need to get this sorted for ITV test tomorrow, i have both dash and BSI on my desk.:banghead:

Except TaсhoUniversal, it is necessary to have and others programmators.
pinky1970
30th July, 2010, 07:09 PM
Sorry i dont understand what you are saying.
Ramzai
30th July, 2010, 07:16 PM
Sorry i dont understand what you are saying.

If it is impossible Tacho, read dumps another programmer.
p.s. Excuse for my bad English.
z786
30th July, 2010, 08:20 PM
you will need another programmer such as UPA USB
and you have 2 remove eeproms off board mate
pinky1970
30th July, 2010, 10:08 PM
Needles now off, after turning clockwise after stop and needles pulled, will program tomorrow and post results.