tuned BOXER 2007

[CIRCUIT.FR]

HI

I would like if i can tuned BOXER 2.2HDI year 2007.
It is EDC15, EDC16......?

THANKS

[rsibiza]

HI

I would like if i can tuned BOXER 2.2HDI year 2007.
It is EDC15, EDC16......?

THANKS


Check by getting data with your flash tool...and you will know if it's EDC15/16

[jnoroeste]

Hi M8, after 2003, I think is EDC16.
But, chiptuning tool will tell you as rsibiza said.

[rsibiza]

Hi M8, after 2003, I think is EDC16.
But, chiptuning tool will tell you as rsibiza said.


Not for sure.

Did an alfa phedra,from documents was an 2006,but maybee was older product date.

Anyway this car also 2.2 engine from PSA had EDC15 inside...

The safe way,look at the ECU,or get data by Flash tool.

[CIRCUIT.FR]

OK

When i have car, i control that...

Thanks

[CIRCUIT.FR]

HI

I have find ecu, it is a VISTEON....
Can you read this ecu for obd tool or read eprom with programer???

[rsibiza]

HI

I have find ecu, it is a VISTEON....
Can you read this ecu for obd tool or read eprom with programer???


What flasher you use?

Connect it,and get data or ID ECU,depending on what tool...and you will see if you can read and write this ECU

[rsibiza]

Have checked carlist for Flashtec

The boxer doesnt exist in carlist...

You may try open ECU and search for Flash or eprom

[rsibiza]

OK,wait...found something about tableflashing

Its a visteon DCU102?

Needs solder 2 x 1kohm resistor inside ecu,and flash by K-Line on connector and vcc+ gnd

check this image;)

[CIRCUIT.FR]

Sorry i can't read zip file.
Could you give me again?

[rsibiza]

Try maybee rename it .mht

[CIRCUIT.FR]

Try maybee rename it .mht

Sorry but when i unzip this i have archive error....

[easytech]

Does anybody know how to change the speedlimiter in these Vistoen ecu's?

[del635]

Not for sure.

Did an alfa phedra,from documents was an 2006,but maybee was older product date.

Anyway this car also 2.2 engine from PSA had EDC15 inside...

The safe way,look at the ECU,or get data by Flash tool.
Also done a 2006 boxer with 3 plug edc15
edit, I should read the whole in future :)

[CIRCUIT.FR]

Try maybee rename it .mht

Could you give me other file please.......

[CIRCUIT.FR]

SORRY

But i can't read this file.....

Please help me

[CIRCUIT.FR]

please could you give me ather information....

THANKS

[LATTINO]

OK,wait...found something about tableflashing

Its a visteon DCU102?

Needs solder 2 x 1kohm resistor inside ecu,and flash by K-Line on connector and vcc+ gnd

check this image;)


please can upload again the file?

Regards