2M5T 14B056 DE

[jedrzej30]

Hi,

I need help with 2M5T 14B056 DE ecu. I have no idea what is the problem. Trouble code 54 before and after clearing. This is my dump org and after clearing.

Hope somebody can help.

Best regards

[mcm44]

Do you have resistors on pretensioners?

[aquer]

Hi,
Check the codes according to this table. Kody migowe systemu AIRBAG - Porady - Ford Club Polska .:: fordclubpolska.org ::. (http://www.fordclubpolska.org/porady.php?action=go&zakres=fusion&type=40)
It turns out that badly cleaned sensor.
Regards.

[morfej]

Is you airbag ECU from your car or you got second hand one ? as erro is "Central module configuration error" ?

Maybe is the configuration problem.

[jedrzej30]

Hi,

Thanks guys for your replys. Yes I have resistors on pretensioners. This car is Focus 2004 so fault is not 5 and 4 but 54 I think. I was checking this fault and this is "Central module configuration error". But I can't clear this fault. Do You have some ideas how clear this fault?

[mcm44]

Yes I have resistors on pretensioners.

This is your problem! You can't simulate pretensioners using resistors in this car... :]

[jedrzej30]

I don't understand what you want say. I can simulate pretensioners whenever i want but i do that only when i want check that i do good my job (clear crash), after that I remove resistors :). Please tell me why a can't simulate pretensioners?

Best regards

[jedrzej30]

You have right. I can't simulate pretensioners using resistors in this car.So I used resistor and capacitor and everythig works fine :)

Problem is solved

[morfej]

Finally mystery is solved :)... I would expect that diagnostic would give you a DTC about pretensioner problem.