Delphi ecu pinout BDM connector

[Satmanek]

Seek pinout and descrypion pin BDM connector for Ford Dephi 4S71 ecu and pinout china BDM100 to read MPC

[Mac Gyver]

Satmanek,

you have photos of the board of the ECU?
attach to the post please.

[Satmanek]

This some Bild:Delphi Ford.jpg - OBD-Wiki (http://wiki.obdtuning.com/?title=Bild:Delphi_Ford.jpg) a i know pin 1 and dont know name other pins. Firt step with BDM. For test XProgM read MPC5xx.

[Zmann]

Download this User manual BDM100 (http://www.evc.de/en/download/down_bdmtogo.asp) , it's in there.

[Satmanek]

No, in this manual write where is pin 1, how connect oryginal cable, where is power ecu, ect... Where is pads DSCK,DSDO,SRST,PORST,DSDI... signal ?

[Zmann]

Yes. If your Delphi BDM pads are not mirrored, they should conform to the Motorola BDM standard pinout found in the almost last page of the document. The pin 1 will guide you to all the rest pins.

Don't know the ECU pinout but the clear photos may help.

[rappttor]

dont try to experiment on it, it is true, wiki gives the location of pin1, but the rest can be switched, and if you dont know for sure the pad arrangement, you will f..k the ecu up for sure....

so if someone tested it yet feel free to share the info

regards

ps: if you still want to experiment, just a sugestion, dont let the bdm to vcc the ecu, use ecu vcc...

[elchip]

dont try to experiment on it, it is true, wiki gives the location of pin1, but the rest can be switched, and if you dont know for sure the pad arrangement, you will f..k the ecu up for sure....

so if someone tested it yet feel free to share the info

regards

ps: if you still want to experiment, just a sugestion, dont let the bdm to vcc the ecu, use ecu vcc...
Yes never supply ECU from BDM and if you connect wrong dSO , DSI and CLK it is not problem only communication did not work..
Regard's

[jaelgti]

Never too late