XPROG-M DAMAGE

[Hayssam1]

Hi to all
Please can you help me ? I need to know The number of the Capacitor or Condenser or Kondensator . I will make to repair of my xprog-m

Thanks for your help

[Dunker]

Can you not measure the same ones around the damaged one? Is it a clone?

[Hayssam1]

Can you not measure the same ones around the damaged one? Is it a clone?

Thanks for your quick response
Yes is made of china clone.
I input 12 V batteries,the programmer is working well. after 10 minutes I smell of smoke then no longer works :( I opened

Then one has seen the broken capacitor but I need the correct number
Regards Hayssam

[Mac Gyver]

Hayssam1,

is probably having the same values of other capacitors that are close to him as it has the same size.
Remove it from the board and with a multimeter measure the voltage that the circuit works, substitute another 5Vdc at least greater than the work voltage.
4.7UF the capacitance.

[bram380]

Original capacitor from xprog-m plastic bos is 4,7uF 16Volt.
For safety use 16Volt or above.

[Hayssam1]

I thank you all. I buy morning SMD 16Volt 4.7 uF. and I hope will work again
Greetings Hayssam

[xito]

Tenho XPROG 4,5 M com ATMEGA64 danificado como posso copiar o ATMEGA64?

Obrigado a todos

[einet]

Amigo, em Ingl?s!
Please in English!

You can forgeht this to bekomme a dump of the atmega!

[xito]

Sorry,
I have XPROG 4.5 M with Atmega64 damaged how can I copy the ATMEGA64?

Thanks to all
:-)

[bram380]

Run software version 5.0
Update your firmware.

[gadroulll]

you can use capacitor smd 475= 47+00000 = 4.7uf poluster

i have the same problem and its working fine know

you must meter your power supply not to be more than 15v without load