PDA

View Full Version : tool for siemens ecu



dott.chem
23rd August, 2010, 01:51 PM
hi all. I want to remap ford fiesta 1.4 tdci with siemens ecu. Anybody knows some tool (clone) to read and write it?
I know it is possible with galletto and one pin (23 ?) to ground. possible?
thanks for your attention.

mexanico1971
18th October, 2010, 03:30 PM
galletto wil do that

rappttor
18th October, 2010, 04:03 PM
if it is simens (804) and not bosch (edc16c34), galeto will not work, simens maybe on bdm...or something that can do can...

rsibiza
22nd October, 2010, 12:36 PM
The Fiesta 1.4 tdci is only Siemens SID804...can be done via CAN with MagPro2...or unsolder flash eprom (29F400 PSOP)

Mpps cant do it....

As i see it should have 29F400 i dont think BDM will do something...

Bosch EDC16+ with M58BW016 is only on 1.6 Tdci Fiesta

rappttor
22nd October, 2010, 12:47 PM
The Fiesta 1.4 tdci is only Siemens SID804...can be done via CAN with MagPro2...or unsolder flash eprom (29F400 PSOP)

Mpps cant do it....

As i see it should have 29F400 i dont think BDM will do something...

Bosch EDC16+ with M58BW016 is only on 1.6 Tdci Fiesta

he is wright....
here is the picture, soldering is the best solution...
http://img651.imageshack.us/img651/1912/sid804.jpg

you can look also for the boot pin...

miha99
24th October, 2010, 06:51 PM
Hot air and Willem usb or LPT with PSOP44 - DIP32
adapterwill do the job, also if something goes wrong with checksum or during writing.Good luck.