help connection tech2 to pc

[morfeo]

hi guys i have problem connecting tech2 to pc, i have try with windows xp pro, and after win7.
com2 to 115200
i used globaltis and i have connection how in pictures
what is the problem?
please your experiences and your support

[Patrian]

hi guys i have problem connecting tech2 to pc, i have try with windows xp pro, and after win7.
com2 to 115200
i used globaltis and i have connection how in pictures
what is the problem?
please your experiences and your support

IF you using USB -----> RS232 Converter-Adapter you need to use 1 OTHER-DIFFERENT from this that you using NOW!!! :evil:

Did not takes ANY role what O/S you using..... :)

Good Luck! :top:

Regards!

[morfeo]

no without usb converter!! i go directly on my port com..i have try also with pcmcia to rs232.
today i try with usb converter...

[Dmitry 42]

You check configuration SPS for work with COM2 ?
I think your SPS try connect to COM1, but Tech2 connected to COM2.

[morfeo]

i have com2 in sps and in control panel

[scotte]

i have ran into this on tis2000

you can set it to use another com port besides com1 and it may communicate sometimes but not perfectly

set it to com1 and it just works

just to clarify i have seen this on multiple different pc's and different connections (both motherboard mounted and keyspan usb adapter)

[morfeo]

i have try also usb converter ecc...

my problem is this, software try to connect to tech 2 and tech2 go to download mode rsr232 connection, on the software appears "init device", sometimes also "read contents", tech2 work...and after 5 sec appears error E4150
i have try all types of connection and now i surrender....
my tech2 can be defective?

[tramman]

If you have the loop back adapter would this allow you to self-test the tech 2 to see if there are any faults/errors?

[AvechuchoAxel]

Perhaps this is not the solution to your problem, but when I first try co connect my Tech2 to PC i was getting hard time at the beginning.... What I did was just modify the CACHE MEMORY from 20 mb to 60mb After that worked perfect....

Hope this is the light at the end of the tunnel....

Axel
:thrasher:

[morfeo]

Perhaps this is not the solution to your problem, but when I first try co connect my Tech2 to PC i was getting hard time at the beginning.... What I did was just modify the CACHE MEMORY from 20 mb to 60mb After that worked perfect....

Hope this is the light at the end of the tunnel....

Axel
:thrasher:

also with 60 mb not work..

[peko]

hi friend

i'm looking for connection to power supply on tech2 and know how many volt need it

thank you

[MrMack]

hi friend

i'm looking for connection to power supply on tech2 and know how many volt need it

thank you
12v / 1amp is enough.

[eddie8]

I use the same connection that i use to do pass thru programming with my tech2 as I do to connect to my pc.

I use:

Tech2

rs232 cable

a usb to rs232 adapter

laptop with windows xp home


Hope this helps:top: