E60 CAS2 read with Xprog

[kautuvera]

Hi, I want it on the wires connected to this circuit, but none of the images in accordance with the circuit I can not someone help me?
PROGRAMMER : Xprog M 4.5
CHIP : 2K79X

[marinero123]

Hi, I want it on the wires connected to this circuit, but none of the images in accordance with the circuit I can not someone help me?
PROGRAMMER : Xprog M 4.5
CHIP : 2K79X

isn't this one ????

[kautuvera]

I must try again , Except this is not another picture?

[pandora6]

You neeed ready for programming flash. X-prog m with cas work very bad.

[kautuvera]

I read and Wright EEPROM want to, whether there is a problem?

[SadCriss]

isn't this one ????

I think that is the one.
But i dont think there is any problem read and write it whit XprogM I hawe read EDC16 in circuit and work ok.
So these should not be a problem i think.

[nauris]

original Xprog-m works with secured 9s12 in CAS or EZS verry good!
Think you have clone, so good luck frend...

[kareszka]

Hi!
Look this,I read cas 2 with xprog and for me work fine.
Regards

[kautuvera]

Hi
i change the mileage in 525i (2005),cas2 and odometer
the old meleage is 141106km and i like to make it 0 km
pleae help it is very urgent]

chip is 2K79X(DG256) inside

[morito]

hi

try this and post reply

regards

[kautuvera]

These two lines like you but I just did not change

[kautuvera]

change the mileage.if someone can make them from 141,106 km to 40,111 km ?

[kautuvera]

thank you my all friendsbut my colleague made it with BMW CAS3 programmer
once again thank you very much for your attentio