VDO dump 93c46 VW Polo MY1997

[tester2010]

hello, during reading with programmer and clip something went wrong with dump. now, fuel gauge and clock does not work proper. can s.o. give me good dump or help to repair old? unfortunately i have no other cluster to read good dump.

Car: VW Polo 6N 1,0l MY1997
Dashboard: VDO 6N0919860
Defective dump in attachment

Thank you all

[tester2010]

No one can help me?
Please, :celticparty:

[leaserhu]

Try this dump

[tester2010]

hello leaserhu,
thank you. still not working, with your dump i only get ------ in display. fuel gauge and clock do not work, too.
any ideas?

[leaserhu]

try swap byte

or original km?
this is not motometer dash?
please whrite sw nr.& ver

[newgeniehex]

hello, during reading with programmer and clip something went wrong with dump. now, fuel gauge and clock does not work proper. can s.o. give me good dump or help to repair old? unfortunately i have no other cluster to read good dump.

Car: VW Polo 6N 1,0l MY1997
Dashboard: VDO 6N0919860
Defective dump in attachment

Thank you all
hello
Be carefull you must to read eeeprom in mode 93C46 X16!!!
for read and write the mileage!!!

[marinero123]

hello, during reading with programmer and clip something went wrong with dump. now, fuel gauge and clock does not work proper. can s.o. give me good dump or help to repair old? unfortunately i have no other cluster to read good dump.

Car: VW Polo 6N 1,0l MY1997
Dashboard: VDO 6N0919860
Defective dump in attachment

Thank you all

you have a wrong reading of your cluster. you read eeprom x8 and you must read x16 !!!!!!!
compare your dump with that one from leaserhu and will see

[tester2010]

thank you for helping,

leaserhu
no its not a motometer it is a vdo. where can i find version and soft nr.? what does it look like?

newgeniehex and marinero123
do you mean 8bit and 16bit?
I did reading and writing in 8bit mode...

Thank you all

[tester2010]

i managed to get it working!
i used 93c46 16bit in programmer soft and swapped the kilometer bits in your file.
now everything is working fine, thank you so much!

[knok]

i managed to get it working!
i used 93c46 16bit in programmer soft and swapped the kilometer bits in your file.
now everything is working fine, thank you so much!

finally you understood what mean x8 and x16. It?s very dangerous when you work onto other more expensive unit and "destroy" original contents...