Star Diagnosis Multiplexor Caesar Test Failure

[dragomirg]

Hello,

I have a problem with one Star Diagnosis multiplexor. It does not connect to most units in the car. I checked the connections - there is no visible damage. Also, I checked the wires from the multiplexor to the diagnostic connector and they are OK. I tried with many versions of Star Diagnosis (DAS 2007/2008/2009 and even 2010) and the result is always the same).

I have attached a CAESAR test. Could someone please let me know if there is anything I can do to fix the multiplexor? Thanks in advance.

[mercis]

this seriennumber from chinaclon,bad quality
send back

[starkey]

this seriennumber from chinaclon,bad quality
send back

HI please i have this error , is posible repair the multiplexor? i give photo thenks
FAULT (1.1)-1.501.9551
SystemCheck :
Check serial ... 0 Ok
CAESAR HW Detection :
D2Access ... 0 Ok
D2DownLoad ... 0 Ok

CAESAR Part D2 detected on COM2 with baudrate: 19200
CAESAR version check :
D2CheckSNVER ... 0 Ok
User is Daimler-Benz AG
User Authentification 1
Classification 0
Serial Number 029866
Authorization Level 4
Part D
Hardware Authentification 011205
Hardware Date 031205
Special EEPROM check :
D2 Special EEPROM check:
Inst. date registered ... 0 Ok
D2 Special CAN Test :
Special Test ... 0 Ok
CAESAR version check :
D2CheckSNVER ... 0 Ok
User is Daimler-Benz AG
User Authentification 1
Classification 0
Serial Number 029866
Authorization Level 4
Part D
Hardware Authentification 011205
Hardware Date 031205
Slave check :
D2 Slave check
D2 Processor ... 0 Ok C165 (mask step CA) is mounted.
D2 RAM ... 0 Ok
D2 FLASH ... 0 Ok
D2 EEPROM ... 0 Ok
D2 SERCTL1 ... 2003 DSR / DTR lines at UART1 not connected
D2 UART1/2 ... 0 Ok
D2 ADC ... 0 Ok
D2 Display Power Supply :
D2 Power Battery ... Voltage KL30 = 13.0 V
D2 Power Ignition ... Voltage KL15 = 00.3 V
D2 Voltage K-Lines :
D2 State K-Lines (35) ... Total 0 (+), 35 (-)