View Full Version : siemens siruis 34
kevfield
10th September, 2010, 01:45 PM
Hi can anyone help with immo off for clio 1.4 16v 2002, had some problems with uch and now need to remove immo i have tryed to search round forum but cants seem to find 34 only 32
Thanks kev
radiotrip
10th September, 2010, 02:18 PM
Siemens sirius 34 uses so called IMMO 3 sistem, whu uses CAN comunication for link between ECU and UCH. So far i haven't seen any working solution for IMMO3 emulator, who should work with virgin ECU.
So far i only heard that SIRIUS34 can be made immo off by software patch, and the guys whu can do it probably have DAMOS files. It CANNOT be done in eeprom block area from 4000h to 10000h. In short words; no useful solution so far.
The best way is that you try to repair UCH (check for bad soldering under black connector, water damage,...) or replace hw and copy eeprom, immo data is the same for all versions. Diferences are for coding data.
Regards
Porelo
10th September, 2010, 03:20 PM
Test
Regards
Porelo
Porelo
10th September, 2010, 03:24 PM
Apology
Sirius 34
Porelo
giedri
15th September, 2010, 12:10 PM
thank for the software
rosenmvr
3rd December, 2010, 06:07 PM
Colleagues please someone help me and give me a ori.bin S118301122 B: 8200326741: 8200326375 - car Renault Clio 1.4 16v and ask overwriting will destroy you key the ignition.
rosenmvr
3rd December, 2010, 06:14 PM
small mistake I apologize. S118301122B: 8200326741: 8200326375
den5
4th December, 2010, 04:52 PM
Make the block new and put the emulator im*o
valdirld
6th December, 2010, 08:58 PM
no need emulator, only erase eprom block and cut resistor in circuit, very easy and work fine, like sirius 32
cardoctor
22nd December, 2010, 01:20 AM
no need emulator, only erase eprom block and cut resistor in circuit, very easy and work fine, like sirius 32
You have immo off dump for sirius 34.?
Please atact some pict and dump here.
Thanks
valdirld
6th April, 2011, 08:10 PM
work on sirius 34 scenic S118301113 B 8200214973, fill with ff from adress 4ff0 to 7fff
darkman30
12th June, 2011, 01:28 PM
Very good work!!!
Thank you!
tas_daz
18th July, 2011, 08:56 PM
make all ff and the cut any pin?in sirius 34?and in the sirius 32 cut pin 58 and take of the resistor and work with out emulator?make all ff or make ff the 64 c7 and 2 more units before make ff?thanks and if you have any photo from sirius 32 the resistor
kophiphi
22nd July, 2011, 08:37 AM
hello thanks
eric paris
1st September, 2011, 06:05 AM
no need emulator, only erase eprom block and cut resistor in circuit, very easy and work fine, like sirius 32
hello,
what eprom must be erasing ?
thanks
eric
v11
27th October, 2011, 08:27 AM
Please ... need pinout for ECU Sirius 34 and pictures with pin bootloader . and pins with K.Line.
Thank you.
daquima
30th April, 2015, 01:19 PM
Thankyou very very much for your post!!
budG60
8th June, 2015, 06:54 PM
Can anyone confirm that this sirius34 immo off solution works?
monini64
9th June, 2015, 01:12 PM
try this, i do one yestarday and work fine
ecufix
27th July, 2015, 02:35 PM
try this, i do one yestarday and work fine
Thank you very much works 100%,regards
dadal
9th August, 2016, 08:28 PM
Thank you very much works 100%,regards
hi mate, your sirius 34 was with of without Can-Bus ?
dadal
9th August, 2016, 08:32 PM
try this, i do one yestarday and work fine
can you give me more info about car and engine please,,, I want to save this dump in my archive
works this solution also on renault with Can-Bus ?
Kalectro
15th June, 2021, 02:00 AM
Thanks Monini64. Your file started my kangoo 1.6.
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.