Log in

View Full Version : hyundai ecu repair



d.zio
12th September, 2010, 12:40 PM
can anyone help me with a hyundai lantra??
it has kefico ecu and i have no signal to injectors....i opened the ecu and one capacitor was blow off...i changed all of them (it has 4 capacitors) but nothing....what else can i look or change??no signal to injectors.....thanks in advance

Mac Gyver
13th September, 2010, 12:33 AM
d.zio,

blew up a capacitor there was something wrong with the car's electrical circuit, for example:
excess voltage due to failure in the voltage regulator alternator.
reversing the battery cables, error caused by some auto electrician.
in both cases most certainly broke down the components of this
ecu.
if you can post photos with good image definition, perhaps even the distance I can help you.
i work with repairs to the ECU, I have a little experience.

d.zio
18th September, 2010, 12:23 PM
this is my ecu

Mac Gyver
18th September, 2010, 03:13 PM
d.zio,

it is possible you put photo on both sides of the board?

impactops
18th September, 2010, 03:26 PM
can anyone help me with a hyundai lantra??
it has kefico ecu and i have no signal to injectors....i opened the ecu and one capacitor was blow off...i changed all of them (it has 4 capacitors) but nothing....what else can i look or change??no signal to injectors.....thanks in advance

What about DTC codes do you get any?

synkrotronic
18th September, 2010, 04:27 PM
Maybe circuit is damage,because capacitor acid or short circuit.
Had this problem once and needed to confirm all circuit around.
After repair some lines ecu worked.
Confirm

Regards

synkrotronic
18th September, 2010, 04:36 PM
Do not know if is the same like i have worked,but confirm capacitor C 108 and bad contacts in the midlle of ecu.

Regards

d.zio
20th September, 2010, 04:52 PM
the first ecu with the bad capacitors is ok.......i changed them and i fixed some lines on the board and all good........the car started properly.....now i have and an other one ecu....the same as the other.....inside is all good but i havent signal to the injectors again.....what else can i check??lines and the capacitors on the board are ok.........what else???

Amine13
20th September, 2010, 09:25 PM
Your photos resolutions is a bit bad man, you should take some high resolutions ones, so the components and leads appear clearly than this.

huseyinkarakurum
27th May, 2011, 08:23 PM
http://www.digital-kaos.co.uk/forums/attachments/f152/31941d1284808944t-hyundai-ecu-repair-ecu003.jpg (http://www.digital-kaos.co.uk/forums/attachments/f152/31941d1284808944-hyundai-ecu-repair-ecu003.jpg) Whehttp://www.digital-kaos.co.uk/forums/attachments/f152/32150d1284997850t-hyundai-ecu-repair-007.jpg (http://www.digital-kaos.co.uk/forums/attachments/f152/32150d1284997850-hyundai-ecu-repair-007.jpg)re does 2ve 3 injections can trigger