View Full Version : ME7.5.10
maRtins.Pt
14th September, 2010, 12:10 PM
Hi,
Can i read the Bosch ME7.5.10 with galetto or kwp2000+?
If yes what is the pinouts of ecu?
thanks
Flash_chip
15th September, 2010, 01:23 PM
Hi,
Can i read the Bosch ME7.5.10 with galetto or kwp2000+?
If yes what is the pinouts of ecu?
thanks
Logically, you can not with the Galletto, because the list of drivers, there is that ME7.5.1 and ME7.5.5.
But I think there are ways with KWP2000 by OBD with the software "KWP2000-ME7".
What is car as you try to read?
keep us updated
maRtins.Pt
15th September, 2010, 03:04 PM
What is car as you try to read?
Is a Seat Cordoba 1.4i
bosch reference - 0 261 207 231
i never tried read, i only asked if is possible, i bought the BDM but at the time i dont have yet.
Now i have the ecu out of car, so if necessary i can read by pinouts.
but i need know if is possible (if we dont know i try) and what pinouts.
regards
maRtins
Flash_chip
15th September, 2010, 03:51 PM
Is a Seat Cordoba 1.4i
bosch reference - 0 261 207 231
i never tried read, i only asked if is possible, i bought the BDM but at the time i dont have yet.
Now i have the ecu out of car, so if necessary i can read by pinouts.
but i need know if is possible (if we dont know i try) and what pinouts.
regards
maRtins
Two SCREEM to read your ECU in boot mode, do not forget to put the pin 24 to ground.
maRtins.Pt
15th September, 2010, 08:50 PM
Two SCREEM to read your ECU in boot mode, do not forget to put the pin 24 to ground.
the pin 24 of eeprom?
thanks
maRtins
Flash_chip
16th September, 2010, 02:25 PM
the pin 24 of eeprom?
thanks
maRtins
Yes, the pin 24 of flash EEPROM, looks picture.
littco
28th December, 2010, 05:53 PM
This was what I was looking for, thanks for posting. shows searching works
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.