08 BMW 535i PROGRAMMING FAILURE

[jollo]

Hello

I did upgrade a lot of bmw's in the past and this is the first time it happened (please see attached pic)
It is 08 535i and most of the modules failed to program and now the car is dead. Do you guys know what I did wrong?
I used orange OPS and progman v32.
Is this version too old or .... I don't know.
Thanks a lot.

[jjrp255630]

you have opps?

[jollo]

yes i do have the opps and it was connected through obd2 and fiber optics
thanks

[jollo]

guys please any idea?

[dlink]

Reset the battery first.Remove one cable for a couple of hours.Try again after that to reprogram.If the key does not lock anymore in ignition you can try to power up the CAS manually.Sometimes is working.
If does not work you can take the CAS and the key from another car, start the measure, but before pressing accept the measure plan, install back the original parts.
Sometimes is working.
If does not work for you, you need a new CAS or a new gateway(if the CAS is ok).
Could be a problem with the head you use,cable, OBD or optical, with the power supply, with the software...it happens.

[_Siemens_]

Hi..

Failure of the D-CAN

Head diagnosis
Cord Head
Improper voltage

:musicus:

[jollo]

Thank you. This is good idea with another cas and key. I will try that tomorrow.

[jollo]

do you know any good supplier of opps heads ?

[jollo]

what is the newest version of sss 32, 34, 37 ?

[dlink]

I have original BMW, I don't know nothing about chinese clones.
I believe 37 is the latest, but has nothing to do with the crash.

[jollo]

Where can I get original tool ?
by the way, here is after math !

[jollo]

Siemens, you where right. it was cable.
Thank you.