View Full Version : how to activate (hack) SDS on RNS-E
jruibarroso
18th September, 2010, 12:14 PM
i need help how to activate SDS (voice recognition ) on Audi RNS-E . I've seen several sites but none explains how to..
My RNS-E is H80 SW0650
tnak you all:barscarf:
jruibarroso
19th September, 2010, 05:53 PM
i just find out how to and i'll share with group
first need to find out sw version, in my case is 650 (i think is the lastest) .
To downgrade the software, have an older DVD or CD ready and follow the steps listed below:
- remove the DVD
- connect with VAG-COM to #37
- set channel 97 to 1 and save the value (allows RNS-E downgrade)
- exit VAG-COM
- insert the CD that contains the software you want to downgrade , old DVD original map(eg 2006, 2007) or DVD with version 620 : http://www.project8e.site11.com/project8e/software/RNSE_Soft/EU_SW0620.rar (http://www.project8e.site11.com/project8e/software/RNSE_Soft/EU_SW0620.rar)
- wait until the RNS-E finishes the update (starts a few seconds after inserting the DVD, will reboot twice and then power off)
- connect with VAG-COM to #37 channel 97 and save the value of 0
After this must upgrade RNS-E with CD with files and soft needed to SDS , where it is :
http://www.project8e.site11.com/project8e/software/RNSE_Soft/EU_SW0660_SDS.zip
It will reboot 2 times , then power up it manualy and check SW version. SDS functions must all work now .
Hope this help you , and please don't forghet to thanks:devil:
kosttis
7th October, 2010, 03:33 PM
Nice..this is my next progect on my rnse!
jruibarroso
18th October, 2010, 10:42 PM
if it was helpful , please thanks
a3sport
20th February, 2011, 06:34 PM
Hi,
What option is there currently a RNS-E "193" B without SDS function with a record on SDS update.
There are indeed some time to RNS-E "193" offered B + G, which support the SDS function.
Greetings, a3sport.
jruibarroso
20th February, 2011, 11:00 PM
for SDS function you must downgrade your RNS-E firmware, and load a higher firmware with SDS function.
Please note to have acess to SDS function you must have a multifunction steeringweel
Please check your firmware version on key "CAR" then SETUP and post it where
a3sport
21st February, 2011, 07:10 PM
for SDS function you must downgrade your RNS-E firmware, and load a higher firmware with SDS function.
Please note to have acess to SDS function you must have a multifunction steeringweel
Please check your firmware version on key "CAR" then SETUP and post it where
Hi jruibarroso,
thanks for the reply.
On my RNS-E "... 193 B" is the SW: 0200
My Audi A3 steering wheel has been the key SDS.
Is there a way, as in the "old" RNS-E ... 192, flash the firmware with SDS function itself?
Greeting a3sport.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.