Renault Clip tester 1. gen.

[hmeyer]

I'm building a clip tester, the old version pre. CAN sonde.
I now "only" need the diagnostic cables (for the 12 and 16 pin diagnostic sockets - old time and new Renaults)
From the included "learning software" I can see it is actually 3 cables I miss, there is apparently one main cable from the clip interface ending in a socket of unknown design (spareparts number: 21818810-7), the 12 pin cable (21819991-0) and the 16 pin cable (21818814-9 or 21821291-1) - But they are no longer available to buy.
The 2 test cables (12 and 16 PIN) are connected in one end to the unknown socket of the main cable.
I have all the other plugs, and intend to make the cables myself, provided I can get a pinout of the setup, which i have not been able to so far.
So can anyone here on this knowledgeable forum help out?

[dly_04_tm]

Try 459 connectors @ pinouts.ru (http://pinouts.ru/connector/)

[hmeyer]

Thanks, looks promissing.

[jdm2506]

some one out there has a set of cables from a chinese clone that dont work ,try asking a new question like ie.
(Cables wanted -clip sonde),If that fails send me a message and i will lend you a set of cables so you can see how the cables & connections are made,

[hmeyer]

Thanks a lot for your offer, but the 1. gen. cliptester does not have a can sonde, the electronic interface is build into the bottom part of of the suitcase, and the cable system is different, I'm afraid.
Will try and find a picture.

[jdm2506]

We are all here on dk to help & get help wherever posible,
Will watch with interest to se how u get on, CHEERS.

[micromax]

plaese share schematic clip ver 1 (without can)

[hmeyer]

Sure :)

I'm quite new here, I was hoping there might be a trained Renault mechanic from the early 1990's, who might help out with the pinouts for this project.