hmeyer
25th September, 2010, 11:26 AM
I'm building a clip tester, the old version pre. CAN sonde.
I now "only" need the diagnostic cables (for the 12 and 16 pin diagnostic sockets - old time and new Renaults)
From the included "learning software" I can see it is actually 3 cables I miss, there is apparently one main cable from the clip interface ending in a socket of unknown design (spareparts number: 21818810-7), the 12 pin cable (21819991-0) and the 16 pin cable (21818814-9 or 21821291-1) - But they are no longer available to buy.
The 2 test cables (12 and 16 PIN) are connected in one end to the unknown socket of the main cable.
I have all the other plugs, and intend to make the cables myself, provided I can get a pinout of the setup, which i have not been able to so far.
So can anyone here on this knowledgeable forum help out?
I now "only" need the diagnostic cables (for the 12 and 16 pin diagnostic sockets - old time and new Renaults)
From the included "learning software" I can see it is actually 3 cables I miss, there is apparently one main cable from the clip interface ending in a socket of unknown design (spareparts number: 21818810-7), the 12 pin cable (21819991-0) and the 16 pin cable (21818814-9 or 21821291-1) - But they are no longer available to buy.
The 2 test cables (12 and 16 PIN) are connected in one end to the unknown socket of the main cable.
I have all the other plugs, and intend to make the cables myself, provided I can get a pinout of the setup, which i have not been able to so far.
So can anyone here on this knowledgeable forum help out?