Bmw e60 help

[autodiags20]

Hi,

I have problems with bmw e60 no power after programing car moving but burbo not work. I do soft update with bmw ops . After this turbo not working. No troble codes in engine ecu.
Car year 2003 motor 3.0d 160kw
Thanks for help and sorry for me bad english.

[Ashraf6119]

Hi

Put back the Original Files................:hmmmm2:

Was the Turbo working before you mess a round with the ECU Program Files ??


Ash

[dimitar]

I have the same problem. Does anyone have a solution on this? Reset adaptations or....?

[alfy]

Hi,

I have problems with bmw e60 no power after programing car moving but burbo not work. I do soft update with bmw ops . After this turbo not working. No troble codes in engine ecu.
Car year 2003 motor 3.0d 160kw
Thanks for help and sorry for me bad english.

ECU HW and SW numbers?

[dimitar]

OK try this e60 525d 0281012091

[ominimicu]

could be the turbo limiter going to limp mode.

[dimitar]

The car had problems before then i updated latest software with SSS progman and same thing turbo still doesnt work. If i move the actuator to full engaged as soon as i put ignition the actuator retracts to disengaged. I hate this car

[diga1]

best is to start vith vacuum pipe that goes to turbo,vhen you start car it must close the turbo if it doesnt you have vacuum problem or actuator problem

[dimitar]

best is to start vith vacuum pipe that goes to turbo,vhen you start car it must close the turbo if it doesnt you have vacuum problem or actuator problem

Yea right thats for golf4 but this is BMW , no vacuum wastegate only servo motor

[borysgo2]

Servomotor is made by Hella, there are two types,1 with can and 2 whitout can. The 2nd one is quite common to go, the 1st one (prapobly one you have in bmw) is driven directly from edc.
Check if after ignition on/off cycle servomotor arm is moveing fully to open/close position - learning cycle.
Check with dis in service function if you have turbo related test plans. Check turbo actuator position in parameters in edc - hall sensor in actuator has to be ok.

[dimitar]

everything ok even tried another actuator same problem

[gtmech]

The car had problems before then i updated latest software with SSS progman

Where did you get the update from mate?

[dimitar]

Where did you get the update from mate?

Progman v3.20