REMOVE FAP DPF from Rnault 1.9 dci

[immokill]

Hello
NEED HELP IN REMOVING DPF/FAP .

Car is Renault Megane 2006 1.9 DCI
ecu num 0 281 012 589 .


Please I need to remove DPF . Any HELP??


Regards

[bazare]

post your ori if you want to receive any help. or at least hw no sw no, car, engine code, year etc.

[immokill]

Ok

car is MEGANE 1.9dci . I read all ecu with DMSPORT and only thing I have is full ecu file in .dim format.

Regards

[Alpinesport]

what and how do you read and save? you only have a info file
do you have a Genius?

[immokill]

hello

Here it is flash file am29bl802c from ecu


Regards

[Alpinesport]

it is a edc16 (not A edc16+) are you sure you have fap?

[immokill]

Yes i have it sure 100percent.
Is my reading of 29b802c good?
Thanks

this is ecu number 0 281 012 589

[Alpinesport]

is it a unset ecu ? wat car is it? the sw read is god! from megane 2 edc16

[immokill]

Car is megane 2 1,9dci ,Can anyone remove dpf?
car starting fine , ecu is from this car.
Regards

[immokill]

Ok

I thing that I removed DPF . Can somebody check my file ?

Please i dont wont to burn my ecu:

Here it is first try ,,,,,
any expert in this ? Please help .
......

It starts and need config with Clip.

all OK

Regards

[kostadinfix]

2 checksum not correct

[teakwon]

SEND ME CODE FOR DOCUM THANKS

[immokill]

2 checksum not correct

Hello


thanks
This file is for diskussion not final .No body answered or send good dump here.

Please help :bandit:

[vyktorio]

Try it

After send me message

[cosmind]

can you tell us the password

[Smac_a]

Hi all,
I (ok, a friend of mine :) ) has a similar problem... So can it be resolved with ecutool and repaired chksum? Or do you have to change position of sensors like i've seen in another thread?

Regards,
Smac_a

[grinovsky]

ecusafe do it

[dbilik]

I have a stupid question. is it possible only with ecusafe to remove dpf? Problem that i have: the car is drive only in city and the dpf is go on every 300 km . The car is Espace2007.. Can i make with same steps like you write in top?

What i need for this...?
I have done some jobs with km corrections in some cars, but never play with dpf..
Can someone help.
Thanks

[Smac_a]

Hi

As you can see in the above posts it is posible to completly remove dpf with ecusafe. I did it on couple of cars, but none of them renault. That's why i was asking if it is necesary to change position of sensors... Turns out that you only have to remove fap (part of exhaust) and reprogram the ecu with ecusafe as with all other brands...
Tools - basicly same as with chip tuning - you have to reprogram the ecu. Word of advice - chksum, some tools can do it some can't so you have to do it (winols, ecm...)

Hope it helps,
Smac_a


I have a stupid question. is it possible only with ecusafe to remove dpf? Problem that i have: the car is drive only in city and the dpf is go on every 300 km . The car is Espace2007.. Can i make with same steps like you write in top?

What i need for this...?
I have done some jobs with km corrections in some cars, but never play with dpf..
Can someone help.
Thanks

[dbilik]

thanks for fast answer.
Can you tell me a toll with that i can connect to the ecu without open it and read the eprom.. I mean like obd or another diagnostic cable.

[Smac_a]

Tools are very specific - very popular now is mpps and kess, then there is galleto and kwp (be careful with clones - when there is error between write you are scr____!). For some you can't even read trough odb (sid 801, 803?), so the only way is bdm 100 or optican. There are a lot of tools, but you will have to choose which one do you need (I doubt that there is somebody that has them all). Anyway look around a litle bit there is a lot of reading material on DK.

Regards,
Smac_a


thanks for fast answer.
Can you tell me a toll with that i can connect to the ecu without open it and read the eprom.. I mean like obd or another diagnostic cable.

[dbilik]

thanx for you help. i will read more about this...

[yas200979]

ecusafe do it
Original or crack ECUSAFE?