PDA

View Full Version : Ineed help with wv passat 2.0 tdi year 2006



jjas40
17th October, 2010, 04:37 PM
hi
I need help with wv passat tdi 2.0 140cv year 2006 with auto trans DSG.
ecu siemens 03G 906 018 ck 5wp45602AA.
the car works bad.
the engine runs on detonation and the yield is low.
injector cables are fine.
pump the tank is fine.
high pump is fine.
no DTCs engine.
no DTCs auto trans.
any ideas?
can be ecu?
injector-pump?
I have read this log
I've also read eeprom ecu.
someone can make me immo off. ecu I can try to rule in another car.
do you have other ideas for this failure?
thanks

tachonow
17th October, 2010, 05:21 PM
Try this dump immo off.
Your problem could be exhaust system.

jjas40
17th October, 2010, 05:57 PM
hi
thanks
exhaust system is also reviewed.
high revs the engine seems to work better.
at low rpms the problem is much larger.
cold also seems to be better

lucianica
19th October, 2010, 08:12 AM
hello
check / replace injector unit 3 or 4,or both (3+4)
by the way.....your car have 136465 km

@tachonow you make immo off with some software for bosch edc16 ecu with 95320,but this ecu is siemens ppd with 95320..............so....will not work
regards

MSolen
19th October, 2010, 08:48 AM
hello
check / replace injector unit 3 or 4,or both (3+4)
by the way.....your car have 136465 km

@tachonow you make immo off with some software for bosch edc16 ecu with 95320,but this ecu is siemens ppd with 95320..............so....will not work
regards

Hi, with what program did you check the km in this ECU?

tachonow
19th October, 2010, 01:38 PM
Hi, with what program did you check the km in this ECU?
Magic Dash or AVDI.

jjas40
19th October, 2010, 06:56 PM
hi
no,the car have 157530 km
greetings

rsibiza
19th October, 2010, 07:03 PM
On that kind of engines,i allready had problems with Injector pumps.

Nozzles may need to be cleaned using ultrasonic bath...

Take Pump injectors out of engine,and give to someone able pass them throuht a ultrasonic bath.

When putting them back into engine,you need do some basic settings...lookm at autodata,or ELSA how to...

For me that worked...2 times...had lot of problems after tuning...ori was ok...after renewing that way..was also fine tuned:congrats: