View Full Version : Meganne/Clio Sagem Nec big problem
marincovich
20th October, 2010, 03:09 PM
Hi All!! I am in problem with this cluster.I am using nec programmer, read program ok and calculate km with tacho soft.When i program new dump into nec processor, read again and its ok.But when turns on cluster, displays 0 km. Read again and dump is corrupted.I also make dump with liznick(binary) and then introduce in nec prog. it displays 83km when i wanted 106000.
Is there any program to change km in adt format?
I think my program is not well done. Thanks all.
technobox
20th October, 2010, 07:06 PM
pls send me how to connect nec pins
tachonow
20th October, 2010, 07:13 PM
pls send me how to connect nec pins
What Nec programmer do you have.
This is for ETL.
kareszka
20th October, 2010, 07:49 PM
See this!Its worked for me .
BR.
MOBILTRONIC
20th October, 2010, 09:42 PM
I when I started with programming in this case with NEC programmer,I had big problems, how to enter the desired content.With the NEC programmer I have not worked long but as far as I can remember must enter 00 of calculations mileage and almost to the end.If not done in the program enroll content but verification is not correct and the result we have a bug in the display.Tachosoft has a different from Licznik 4.0 or 4.8 But, I think, done that like a Licznik and it was all in OK.There are instructions in the ETL even an example of how to work with NEC MCU and I think it will be much clearer.Regards.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.