muleskinner
31st October, 2010, 01:39 PM
Friends,
I need to setup an ECM on an engine so I can configure some parameters. What I have is an issue with an EO93 fault code. It's a low boost alarm and it derates the engine 30% on activation. This engine is running at 14,000 ft and the low boost alarm should not function above 9000. Trouble is it does so I need to reconfigure either the event trip time out (15 seconds) and or reduce the trigger on atmospheric pressure to say 8 psi.
Is there anyway to setup an ECM in test mode so I can reconfigure these parameters to see if it eliminates the fault code or even better can someone out here in DK land get into the flash file and change those two parameters. It's not changing the fuel map or anything critical. It's just turning off the EO93 profile.
There's a good few beers available for anyone who can do it I promise.. It's driving me nuts trying to overcome it.
Any takers?
Muleskinner
I need to setup an ECM on an engine so I can configure some parameters. What I have is an issue with an EO93 fault code. It's a low boost alarm and it derates the engine 30% on activation. This engine is running at 14,000 ft and the low boost alarm should not function above 9000. Trouble is it does so I need to reconfigure either the event trip time out (15 seconds) and or reduce the trigger on atmospheric pressure to say 8 psi.
Is there anyway to setup an ECM in test mode so I can reconfigure these parameters to see if it eliminates the fault code or even better can someone out here in DK land get into the flash file and change those two parameters. It's not changing the fuel map or anything critical. It's just turning off the EO93 profile.
There's a good few beers available for anyone who can do it I promise.. It's driving me nuts trying to overcome it.
Any takers?
Muleskinner