View Full Version : CURTIS Hour
vrsc
15th November, 2010, 10:08 PM
Hi know someone how to overclock this hour meter or calibrated. It consists of a CURTIS.
Greetings
VRSC
kimoe
15th November, 2010, 10:41 PM
is this out of a Fork Lift ?
vageric
16th November, 2010, 07:06 AM
eprom is under display covered with silicon.
ronshamal
8th June, 2011, 12:55 PM
u most use a ocilator not a cristal to speed it up reset is on pin 4 to jump 0
any body know how to reach the eeprom?
kimoe
25th October, 2011, 04:38 AM
u most use a ocilator not a cristal to speed it up reset is on pin 4 to jump 0
any body know how to reach the eeprom?
I once try to reach the eeprom but i got a :eviltongue: ,,,
NO GO , broke the display ,,, not sure if possible to reach the eeprom ( or what ever is in there ) ,, only way i know of is to reset and then pulse generate to desired value :beer:
SDO
14th August, 2013, 05:53 PM
Anyone know how to reset this ?
I have so far
Pin 1 V+
pin 2 V-
pin 3 I
pin 4 RESET
This is where I got it from
http://www.farnell.com/datasheets/32404.pdf
the one I have is F CASE
wieslov
12th June, 2014, 02:19 PM
if curtis..............................
cgtech
17th February, 2016, 04:21 AM
Hi I AM WORKING ON A CURTIS HOUR METER SAME AS YOURS.
DO YOU KNOW HOW TO RESET IT AND ALSO HOW TO SPEED UP WITH CRYSTAL
THAKS CGTECH
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.