dash 406 and DIGA

[CIRCUIT.FR]

Hi

I need change mileage for 406 D year 1998 with Jaeger.
I can read correctly with DIGA.I use cable n?11.
Connection are good (picture documentation DIGA).

Idea?

[marcolr]

And which is the problem?? If you can read correctly, change odometer value with Diga and run.
I don?t understand your problem.
Regards

[CIRCUIT.FR]

I have not good value in reading.
And if changing mileage, no change realy..

[marcolr]

Have you used this cable in the past and it worked well? or is the first time you use it?
You have raised MCU pins where the wires blue and yellow.
I pass you the scheme of that cable to make sure yours is correct and the instructions of this model although I guess you got them.

Regards

[CIRCUIT.FR]

Thanks for picture

It is the first connection for this cable.
I have only raised the wires blue and yellow.

I need raised other pin?

I control cable again and post result....

[CIRCUIT.FR]

I have tested cable and i have R3 10K.
I try change this and test....

[marcolr]

I have tested cable and i have R3 10K.
I try change this and test....
You must raised only blue and yellow wires in the MCU.
Change R3, must be 470 Ohm I think this is your problem.
If help you please press thanks button.
Regards

[CIRCUIT.FR]

SOLVED

You are right, It is fault at R3.
I change it and work correctly.

THANKS

[marcolr]

Good work! ;)

Regards

[abdallah]

work good
thank you very much

[n599fbm]

good friend !!

Tks,

C.

[vuno01]

bro with diga
its like this when in doubt just check the cable
here is the cable schemes and there is a few cables that you have to fix like cable 82 for jeep and a few others