MB CLK208

[elektraauto]

Hello DK,
I have MB CLK 208 with big fish key, wich is not working. Can you chek my dums from key and eis and esl.

[youssef70]

can you rename files spyna vanosto .....
to known names eis1 eis2 esl 1 esl2 etc .....

[elektraauto]

Now is ok.

[elektraauto]

Hy, i still have a problem, i post renamed files, can you help me and chek my dumps, where is the problem in key or in other dums?

[sogaro]

Here is are new dumps for your car, write the dumps back to EIS and renew the ESl and then write key dump, for Motorola 05E6, use version 1 for NEC chip write v2, goodluck.

[elektraauto]

but this is my original dums, not new dums

[sogaro]

my mistake, sorry

[elektraauto]

thank you, i will try it
And what about ecu, i must renew it and make synchronization with star, or leave original dump in it. the ecu is me 2.1

[sogaro]

Don't touch the ecu, use as is.

[elektraauto]

not working

[vanos batam]

not working

pm me.., will help you

[samerrahal]

hiiiiiii nice info

[sogaro]

When you say its not working? what is not working? The key did not turn or car did not start? Write V2 then in to your key, Your dumps are good and so are the new generated ones. Will use them myself by tomorrow and see

[elektraauto]

the key did not turn. my key is big fish and was trying to write v1 and v2. But when i put the key in the EIS the red lamp on the key is blinking and the key didnt turn.

[sogaro]

What tool do you use to write key, as my tool would need to activate key after writing, maybe i generate another set for you using another tool entirely but i will try this out myself using your dumps. This new dumps are for Motorola keys only

[DJAMY]

hi , mates
i dont understand why every times when key dont turn you go directly to generate new EIS and dumps:hmmmm2:

programming keys is last solution when confirm the key data is finished ( counter down to zero )
or key broken
there is to many cases why the key no turn

check the key if sending signal and present
check key hardwar not broken and check the coil with tester
check EIS if present and no faults
check EIS coil
check EVL if ok
check wires and GND /12V

must have for more convinience set of EIS+KEY+EVL (any one ) compatible in hands for testing
if car wirings and voltage is ok

when confirm realy problem is from key
,go to key programming

better to programm new key
the only one case when the orginal key success after programming
is when key died by finish couter to start zero

for information big fish key have 03 kind data
data for 0F82B with 2MGhZ oscill
data for 0F82B with 2MGhZ oscill with some FFFF in line 60
data 0F82B with 4MGhZ oscill
tools generate the correspond data .

[bregsm]

hello sir i have a AK500 how too key copy and right key plz