I*mo Gof IV TDI 110

[zorg3k]

Hello,

i need the pin code for my Golf IV TDI 110
from 12.12.1999 to add one key.
I have vag-com 311 and Galetto 1260.
Can i read the 24cxx ( 24c02 i think ) eeprom
with galetto to post the file ?

Thx in advance.

[chli1976]

It`s IMMO 2, there are no login in engine ECU, you must read eeprom from dashboard

[zorg3k]

I've made a scan with vag-com and for the i*mo i have :

Address 17 -------------------------------------------------------
Controller: 1J0 920 801 E
Component: KOMBI+WEGFAHRS. BOO V25
Coding: 01142
Shop #: WSC 00046
Ident.-Nr. WEGFAHRS.:VWZ6Z0X1234191
No fault code found.


It means there's no need to log in in the key procedure ?

In this case i don't need the pin code ...

If pin is needed, is it a 7 digits or 4 digits pi code ?
Is the 24c02 dump is included if i read the ecu with galetto ?
If not, do i have to read physically the eeprom in a programmer ?

Thanks.

[immokill]

hello


No yoiu cant read it with Galleto. Read it from dashboard. Try with Vag EEPROM programer 1.8,with your vagcom cable.

Regards

[zorg3k]

thanks for answers but no chance.
Connection impossible to immo box with
vag eeprom programmer 1.18 and my blue ( china )
vag-com 409.1 cable.

[lupu_sandu]

You need to connect to dashboard no to immobox.

[zorg3k]

I've tried all modules : dashboard and immo, and each time, got messahe "ECU not found". For me it sounds like a usb driver problem or something like this. Still searching ...

[zorg3k]

... and still no success.
In com1 or com2 mode with vag eeprom commander, message "ecu not found" and in usb mode "unable to connect to HEX-USB-CAN". It seems my vag-com 409.1 is not adapted for communication ( working only in kkl ). A vag k+can would be more adapted ? What do you think about this ?

[mihai_vyt]

you need an eeprom programmer,read eeprom and post the dump

[powerpower]

hi
i use vagtacho 3.01 and it works in that car

[DECOCO]

yes vagtacho 3.01 works for shure on the car