Opel Vectra C CIM HELP!!!

[SnipeR24]

Hello, please help me in this matter ...
Opel Vectra C 2004
Took the OP-COM tried to sew Steering Assistant is not sewn (Fail)
dismantled the CIM exposed to 0-l tried to sew (Fail)
A friend suggested I do reset the SIM and do not know now what to do now he does not recognize my key wants a new key programmed Sec.-y Code generally complete nightmare please help!

I apologize for my English

[Ashraf6119]

Hello

Why did you Reset the CIM Module ? Didn't you know that CIM is part of the Immobiliser system.

Now make sure you DON'T reset any thing else other wise you will loss security files.

Also now be very careful when you enter the pin code in the Cim Module make sure you enter the rite pin code which is for this car.

1) Log into Cim Module and go into immobiliser programming enter the pin code and then program the High Can, Mid Can, Low Can.

2) Than Select Cim Module Replaced, when you do this, it will match with your Engine ECU.

3) Program the Vin Number I am sure it should be there so just click on save.

4) Program the Variant system what you have on this Vehicle.

5) Program the Mechanical Key Number which again i thing it will be there just save it as it is or, if you know just double check if its rite and save it.

6) Reprogram all your keys again.

7) Read fault codes if there any try to clear them

8) Switch ignition OFF for at least 10min.

After that try starting the car once it starts after that you can log in again into Cim enter the pin code and reset your Steering Angle Sensor.

But, make sure while doing this your Battery must be fully charge.

Hope this helps.

Good Luck. :elefant:

Ash

[SnipeR24]

This is a problem I tried with the keys he needs a new key but I do not have

[Ashraf6119]

This is a problem I tried with the keys he needs a new key but I do not have


Hi

It will only need New Keys if you did Even reset the Engine ECU and the Cim Module Both at the same time.

Ash

[SnipeR24]

Agromnoe thanks !!!

Do not even need new keys
sewed old keys with a version of OP-COM 2010

[Ashraf6119]

Agromnoe thanks !!!

Do not even need new keys
sewed old keys with a version of OP-COM 2010


Hi

So have you got this running :questionmark:............. or, you still struggling

Ash

[SnipeR24]

Running thanks !

[Ashraf6119]

Hi

I am glad you got it sorted good....:congrats:

Ash