View Full Version : problem reading PEUGEOT 307 NEC dash
mastaflex
17th December, 2010, 07:43 PM
hello all:
ha ve tryed to read a sagem dash (peugeot 307) with NEC MCU and always have errors. i tryed with NEC PROGRAMMER, UPA and with using wiring schematic of NYO and super tacho. not succeeded.
all wires soldered OK . don't know why :hmmmm2:
markony79
17th December, 2010, 07:48 PM
Do onlly bsi, not need dash
jonnyjetset
17th December, 2010, 08:14 PM
If the Dash has an NEC micro you must also program BSI.
mastaflex
17th December, 2010, 08:22 PM
are you sure have only to do bsi?
but i don't know why can not read
markony79
17th December, 2010, 08:35 PM
Dont exist in dash, only bsi
try and you will see...
markony79
17th December, 2010, 08:41 PM
In dash have nec. but dont have km inside
mastaflex
17th December, 2010, 09:41 PM
car is away now. but according to nyo and supertacho doc, BSI and also DASH have to be done
Digamax
17th December, 2010, 09:57 PM
are you sure have only to do bsi?
but i don't know why can not read
Year 2001 and 2002 only BSI (912 mcu)
After 2003 BSI (95160 or 95128) and dash (Nec or 95020)
Best regards
Vladimir
mastaflex
17th December, 2010, 10:17 PM
ok ! but i don't know why can't read MCU . with nec programmer i have message like in picture attached before and with UPA i have error capture baudrate .
someone have an answer ?
mgrka
17th December, 2010, 10:36 PM
need dash and bsi does not work as raise the 10 SCHWARZ
mastaflex
18th December, 2010, 10:43 PM
what do you mean by raising the black wire 10?
i have tryed to raise the pin that is relayed to wire 10 and connect direct ti mcu pin but still no success...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.