salim
27th December, 2010, 12:14 AM
Hi Gents Seasons greating to all.
I have taken my dash out, but not sure where the soldering points are because mine has 10 holes (4 + 6) on the top left.
If I could remove the needles I would be able to follow pins to mcu to verify which point is which pin, but I am scared to pull off the needles incase they snap.
I have edited the picture to show what i assume are the connection points. Can someone please confirm that I have the correct points
Also do I need to short the crystal if reading upa usb?
Thankyou in advance
I have taken my dash out, but not sure where the soldering points are because mine has 10 holes (4 + 6) on the top left.
If I could remove the needles I would be able to follow pins to mcu to verify which point is which pin, but I am scared to pull off the needles incase they snap.
I have edited the picture to show what i assume are the connection points. Can someone please confirm that I have the correct points
Also do I need to short the crystal if reading upa usb?
Thankyou in advance