Rob Turbo
28th December, 2010, 09:23 PM
I've been looking into remapping my 406 3.0 v6 engine with a motronic MP7.0, I so far understand that the map is found in the CC460, which may contain a 28F010/29F010, I'm not sure on that though, apparently this CC460 can also be found in some BMW ecu.
I know that the ecu can be written via the obd connector because I've updated the software of the ecu with peugeot planet, I'm not too bothered how I read and write it, I don't mind opening the ecu and even removing the CC460 if needs be!
Surely something I have can read and write to this ecu, I have a willem, xprog-m and a galletto 1260. What I need to know really is the pinout of the CC460 to enable to read/write the internal flash, I read that EVC have an adaptor that will enable the CC460 to be programmed as a 28F010, but that is out of the question!
Has anyone had any experiance with this ecu/chip that could share any information?
Thanks,
Rob
I know that the ecu can be written via the obd connector because I've updated the software of the ecu with peugeot planet, I'm not too bothered how I read and write it, I don't mind opening the ecu and even removing the CC460 if needs be!
Surely something I have can read and write to this ecu, I have a willem, xprog-m and a galletto 1260. What I need to know really is the pinout of the CC460 to enable to read/write the internal flash, I read that EVC have an adaptor that will enable the CC460 to be programmed as a 28F010, but that is out of the question!
Has anyone had any experiance with this ecu/chip that could share any information?
Thanks,
Rob