Standalone WIS 10.2010 install error message

[mercecrac32]

Hi,

When installing WIS standalone, it stops and displays attached message. Any idea ? Maybe wrong startkey ?

Has someone a good startkey ?

ID LAN 4E287842FF1B
ID Program 54

Best regards,

[weryo]

the error messages clearly explains the reason of the trouble itself!

register your unibox10.ocx and go ahead!
You may face another error message,..but google it,..and try again!

a tip:
run\regsvr32 UniBox10.ocx

[mercecrac32]

Hi Weryo,

Done as explained, works perfect ! Thank you very much.

Now another problem because install stops later on and attached message pops up. What do you think ?

[weryo]

uninstall wis net standalone,..

and install it from the right application.

[mercecrac32]

Hi weryo,

I completed standalone wis installation thanks to all pieces of information from DK members scattered around the forum , ouf !

It works fine except when called up from DAS from where it does not open. I only get attached DOS screen then nothing else. I applied patch "enable wis in xentry" from our friend mercedesUSA without success

DAS/XENTRY are 09/2010

WIS version is 10/2010

WIS installed in C:\program files\EWA net - WIS net Standalone\wisnet\

Patch installed in C:\programme\EWA\wisnet\

Any idea ?

I add that it does not work neither in SIM mode nor connected to the car

May be wrong wis startkey ?