cas3 need info

[jjrp255630]

hi people, i have a cas3 black, i need to clone it, i have r260 and UPA, its possible do it?

i need only to copy eeprom or need flash too?

regards

[squirrelbandy]

if you can read ok rewrite whole flash hoping the old flash wasnt damaged .
if not just try reading and writing the eeprom then if dont work properly read and write the flash.

[DJAMY]

if same softwar version and
HW/SW/cod/diag-index

just read and write eprom of ST 12 MCU
it will be ok

[jjrp255630]

ok, but i can read and write the full MCU with rosfar?
i have try but with no sucess with rosfar and UPA.

regards

[tachonow]

Etl or xprog original can solve it.

[bassit]

hi!
but for xprog must remove the mcu or what?
any body have tested xprog on all cas?
it's trust tool on cas??????
and for etl too?????
thank u

Etl or xprog original can solve it.

[paradoxtr]

You can read with xprog eeprom and flash. No need desoldering chip. I tested it on many cas. Its very trustable.

[obdmaster]

You can read with xprog eeprom and flash. No need desoldering chip. I tested it on many cas. Its very trustable.


Please tell me m8. Do you use original xprog or clone, as im toying with idea of buying original?

[cardoctor]

Its solved with old x prog T in win98
Telwis - Programatory, elektronika samochodowa oraz diagnostyka (http://www.telwis.pl)

[paradoxtr]

Please tell me m8. Do you use original xprog or clone, as im toying with idea of buying original?

I m not sure my xprog original or clone, i bought it one year ago from Ebay and pay it 600?.