IMMO off on Peugeot 406 EDC15C2 3 plug

[bcl]

Hi everyone,

Reading eariler posts on this seem confusing. Does anyone have a solution for the 3 plug ECU. This car is a 2.2 HDI. I have attached the original 5P08 dump if its possible can someone post a IMMO off edit

Thanks

Brent

[grinovsky]

immo off 406 2.2

[bcl]

flashed onto ecu and still no start. The car has had a matched bsi and ecu but looks like bsi has been opened. not sure if the car doesn't need another bsi. In engine ecu it won't let me erase any fault code, it says erasing impossible. Also engine ecu still locked. Any ideas?

[grinovsky]

so if there is a communication with ecu the bsi is good
the ecu is locked and i think because it was flashed by obd tool and the checksum is wrong
try to programme an original dump in ecu

[bcl]

so i need to flash an orginal engine map to ecu and redo 5P08 or just flash engine map with a file on here. or update using PP2000. ECU is 0 281 010 877. The original problem is the key or even new key won't code to the bsi. Maybe its better to clear everything and start again. I will try engine ecu first.