Log in

View Full Version : Dash Ibiza problem after correct



bodzio012
12th February, 2011, 02:18 PM
Hi!!!
I have problem with dash ibiza 2003y TRW, after correct dash is death, I don't know why, maybe somebody remember , maybe my hot air flow he blew out resistor, you look on photo, there are 2 resistors, maybe should be 3 resistors?


http://obrazki.elektroda.pl/9663748900_1297516701_thumb.jpg (http://obrazki.elektroda.pl/9663748900_1297516701.jpg) http://obrazki.elektroda.pl/1089008100_1297516701_thumb.jpg (http://obrazki.elektroda.pl/1089008100_1297516701.jpg)

exe123
12th February, 2011, 03:11 PM
make better picture. you can't see anything on this picture. maybe it is some pullup resistor for eeprom but even without it the dash should do something

bodzio012
12th February, 2011, 04:59 PM
ok

http://obrazki.elektroda.pl/4319722400_1297526327_thumb.jpg (http://obrazki.elektroda.pl/4319722400_1297526327.jpg)

d.zio
12th February, 2011, 05:10 PM
maybe you soldered wrong the eeprom??
did you mark the pin 1 when you desoldered it??

exe123
12th February, 2011, 05:25 PM
pin one is the pad right bottom.
the both resistors are 3,9k ohm pullup for sda and scl.
the one which isn't soldered is for write protection.

bodzio012
13th February, 2011, 07:07 PM
Ok Thanks, I looking for why the dash is death

drpeter
13th February, 2011, 07:25 PM
Ok Thanks, I looking for why the dash is death

This is the right setting, clean the mess and check if all solderings are ok.