aidyk
17th February, 2011, 11:35 PM
customer changed cluster on this and wants it programmed
i have full working VCDS and K+CAN commander can i do it and whats needed please..?
tachonow
17th February, 2011, 11:43 PM
customer changed cluster on this and wants it programmed
i have full working VCDS and K+CAN commander can i do it and whats needed please..?
You need both dash pin codes.
aidyk
18th February, 2011, 12:00 AM
You need both dash pin codes.
can either these tools i have extract them..?
thanks
markony79
18th February, 2011, 12:08 AM
If you have old dash, put this in car, use K-can comander,
use K-line
open cluster(kombi) , read eeprom,and SAVE somewhere in comp
then put another dash, open cluster, Load eeprom and write in
then ingnition OFF and wait 15 sec, and then start car
If not have old dash, must read pin code, and progrma new keys
diga1
18th February, 2011, 08:51 AM
just swap eproms
diga1
18th February, 2011, 08:54 AM
just swap eproms if you have both clusters
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.