PDA

View Full Version : CMD1255



Harrycz44
21st February, 2011, 08:22 PM
Hello All. Pleas where is on this CMD1255 pin1? I do not want demage my ECU.. thank you

bazare
21st February, 2011, 09:22 PM
by looking in my crystal ball is on the left :)) measure the grounds man!

Harrycz44
21st February, 2011, 09:38 PM
by looking in my crystal ball is on the left :)) measure the grounds man!

But I have red cable on right side... is this convertet? (china)

Harrycz44
21st February, 2011, 09:40 PM
how I can test it? I want connecting bmw edc16

Harrycz44
21st February, 2011, 10:58 PM
I ADD new picture. Is that correct?

Harrycz44
22nd February, 2011, 11:50 AM
Pleas where is pin 1 and 10

alfy
22nd February, 2011, 12:21 PM
Pleas where is pin 1 and 10

I think that pin 1 is upper right (where you wrote pin 10).
Measure the two pins near (yours 9 and 6) if they are both GND, than i'm right!

bazare
22nd February, 2011, 12:25 PM
have you read my post? MEASURE THE GROUNDS!!! then come back here and tell us where you have grounds and I will tell you where is pin 1. please read before posting again and again and again! If I tell you a stupid thing based on my assumptions and you will burn an expensive ECU who is going to pay for it? Me or you?

Harrycz44
22nd February, 2011, 12:59 PM
have you read my post? MEASURE THE GROUNDS!!! then come back here and tell us where you have grounds and I will tell you where is pin 1. please read before posting again and again and again! If I tell you a stupid thing based on my assumptions and you will burn an expensive ECU who is going to pay for it? Me or you?

I have GND on PIN5 AND 12v pin2 AND pin9 on my picture

alfy
22nd February, 2011, 01:09 PM
I have GND on PIN5 on my picture

Maybe will help:

Bals-online.ro • BDM 100 show connection instruction for pads (http://forum.bals-online.ro/viewtopic.php?f=38&t=608)

bazare
22nd February, 2011, 01:51 PM
check the grounds on the ECU also

Harrycz44
22nd February, 2011, 05:24 PM
THANK YOU ALL.... BAZARE ALFY YOU ARE GREAT DK

egyclick
23rd February, 2011, 10:28 AM
THANK YOU ALL.... BAZARE ALFY YOU ARE GREAT DK

nice to see it helped, that topic Bals-online.ro • BDM 100 show connection instruction for pads (http://forum.bals-online.ro/viewtopic.php?f=38&t=608)

was made by me after I burned an ECU from a BMW and paid 1000euros for a new one.
beware and have patience reading and measuring the BDM clone before using it, I learned that the hard way.

VTS_Tibi
6th September, 2011, 01:04 PM
here's my BDM100:

http://i1115.photobucket.com/albums/k545/TestorVTS/sajtBDM100.jpg

I only have one GND at the lower middle pin - with a red circle on the picture!

Can anyone tell me which one is pin1?

macxlulu
6th September, 2011, 01:55 PM
all bdm 1 pin is top right

A:bad clone
b:good clone reading sid803
c:dimsport org