PDA

View Full Version : WILLEM PROGRAMMER AND 29F040



newgeniehex
21st February, 2011, 10:23 PM
hello
i would repair my tacho pro V2008 because it don iwork
i have willem programmer
i can read the chip 29F040 ic 112 but i cannot write ??before i use erase chip???
my chip it is good position for read and write or i must to use adapter:
B01 ] PLCC32 to DIP32 Adapter
thank in advance for your answer

d.zio
21st February, 2011, 10:32 PM
what problem do you have mate with your tacho 2008??sync problem??do you have solution for this problem??

newgeniehex
22nd February, 2011, 06:59 AM
what problem do you have mate with your tacho 2008??sync problem??do you have solution for this problem??
Hello
go to:
http://www.digital-kaos.co.uk/forums/f155/tacho-universal-out-order-190738/
thank in advance

karalada
22nd February, 2011, 05:14 PM
First erase and then write chip.

zoro1
22nd February, 2011, 06:12 PM
use windows 98 se or this
http://www.digital-kaos.co.uk/forums/attachments/f176/48275d1296320058-flash-programmer-circut-willem60.zip
software for windws XP

newgeniehex
22nd February, 2011, 07:20 PM
First erase and then write chip.
HELLO
i have aleady read and save the dump!!
after i i have erase the chip, but after erase the chip , i read it and i find a same dump before i erase it????
i open the good dump ant try to programe ,but i canot???
why????
the position in my eeprom in the willen it is good?
another question in the menu device i find lot 29F040???
many thank in advance

zoro1
27th February, 2011, 12:42 PM
see in pdf datasheet voltage programing for your F040 ,and then with jumpers set the correct voltage.there is so many types of flash see what willem says for yours./test device/
position is correct.

zuzuss
27th February, 2011, 01:19 PM
you have 2 soket with 32 pin ,one fwh\lpc and one plcc32 use plcc32

grinovsky
27th February, 2011, 09:01 PM
this jumper is in wrong position if you want read 29f040
move it to the other position