raztech
27th February, 2011, 01:52 PM
Hello everyone, i have read through various posts and replies on the airbag section.
I would greatly appreciate any help or advice on the best way of reading airbag crash data from the different eeproms.
I am aware there are a few diff type of eeproms depending on the airbag module you are clearing.
What is the best way of getting a good read without removing the chip off the board as i am not very good at desoldering / soldering.
I use a standard SOIC 8 pin eeprom cable, but have struggled reading many Ford 2006 -. NISSAN 2006- , VW 2006- and Renault airbag modules.
Any help would be greatly appreciated.
Regards
Raz
I would greatly appreciate any help or advice on the best way of reading airbag crash data from the different eeproms.
I am aware there are a few diff type of eeproms depending on the airbag module you are clearing.
What is the best way of getting a good read without removing the chip off the board as i am not very good at desoldering / soldering.
I use a standard SOIC 8 pin eeprom cable, but have struggled reading many Ford 2006 -. NISSAN 2006- , VW 2006- and Renault airbag modules.
Any help would be greatly appreciated.
Regards
Raz