View Full Version : Pontiac Sunfire 2002 BCM
sawatdee0999
10th March, 2011, 02:09 AM
Pontiac sunfire 2002 BCM 93C66
Original Miles = 25
Can someone change the mileage in this data. I've tried with tacho soft. Offset 0190 but i would always get 0 miles.
First time i put the BCM computer inside the vehicle. i get 25. Now the miles stays at 0.
115000 - Is the Mile i want.
Thanks.
vageric
10th March, 2011, 06:00 AM
post dump.
sawatdee0999
10th March, 2011, 09:18 PM
My bad i thought i posted the dump xD. There you go.
paul_mike
11th March, 2011, 05:12 AM
Try this one
sawatdee0999
11th March, 2011, 06:34 AM
I will try it tommrow for you. I will let you know.
sawatdee0999
11th March, 2011, 10:40 PM
I tried your dump and i get 0 mile.
maumaumau
12th March, 2011, 04:42 AM
you forgot to post one of the most important terms in the equation...original miles please
paul_mike
12th March, 2011, 05:30 AM
(http://www.digital-kaos.co.uk/forums/members/212136-sawatdee0999/)could you reread your eeprom, I've found a old file and the calculation is good but the address on your dump is different , yours start at x192 and mine at x19E
the chip was a 93LC66A on mine
sawatdee0999
12th March, 2011, 06:05 AM
you forgot to post one of the most important terms in the equation...original miles please
Sorry, about that i will fix that up now. I will edit the First post and Paul_Mike i will reread the chip as 93LC66A. I was reading it as 16 bit. Also i use GQ-USB Programmer. That could be why the offset are different? o.o. You will get the reread data tomorrow morning.
sawatdee0999
12th March, 2011, 05:49 PM
Here is the 93LC66A data for the Pontiac Sunfire 2002. paul_mike could you send that old file as well. Thanks
paul_mike
12th March, 2011, 08:31 PM
Here's my 2003 sunfire file untouch. According to the VIN in your file this is a 2001 vehicle .
I swap the byte into your file too , you may want try that 1st.
bender
12th March, 2011, 09:04 PM
Pontiac sunfire 2002 BCM 93C66
Original Miles = 25
Can someone change the mileage in this data. I've tried with tacho soft. Offset 0190 but i would always get 0 miles.
First time i put the BCM computer inside the vehicle. i get 25. Now the miles stays at 0.
115000 - Is the Mile i want.
Thanks.
Did you de-solder the Chip out from the board to read?
sawatdee0999
13th March, 2011, 05:28 AM
Did you de-solder the Chip out from the board to read?
I've try to read it on board before. Therefore i didn't get any read out. So i de-solder it off the board.
DOUGLASMAITA
22nd June, 2016, 03:29 AM
I need inmo off sunfire please memory flash 29f400
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.